Coloring my receiver tubes

I was looking for a way to change the color of my receiver wires as they were shiny/reflective and a little more visible than i wanted. I came across a dye product -


(also sold on Amazon)

Initially i was thinking of buying it but instead bought a small pack of dye for very cheap and decided to do some DIY. I first used a small piece of super fine sandpaper to create a rough surface on the tube so that it looks like frosted glass, this is so that the dye can penetrate the surface of the receiver tube.

Then mixed the powder dye with boiling water and let the receiver sit but it did not work, it was tricky too as i did not want water in the receiver unit. Perhaps this may still work when done properly, it seemed like a lot of hassle as i did not have a soaking tray like supplied with the Vanish kit.

I then decided to try using a permanent marker and went for -

http://www.winsornewton.com/row/shop/graphic-markers/promarker

Again lightly sanding the tube is required, otherwise the marker will not apply very well. I then simply marked it with my color of choice (cinnamon)

As you can see the standard receiver on the right side is quite shiny and more visible, when next to skin you can really tell the difference. I have fair skin and the darker receiver actually blends in quite well. For some reason the marker turned out much darker when applied to the plastic on the tube so be aware of this when choosing a color.

At first you may need to reapply the marker every couple of weeks but for me it’s been six months and now it seems to be permanent.

So for anyone who wants to make their receiver tubes a lot more discreet, this is a simple and cost effective solution.

I wouldn’t advise this. You may damage the unit. Is what you used safe to place in your dryer unit? What about fumes? And you likely just voided any warranty you have left. (Companies look for any excuse to say a warranty was cancelled due to user intentionally caused the problem.).

Meantime, tube twists are a big hit, they don’t go in the dryer unit and easily swap daily depending on what you are wearing.

One link here: Hayleigh's Cherished Charms -       TUBE TWISTS - all new - PATENT PENDING        SILICONE TUBE TWISTS!!!!   

1 Like

I find that hiding my hearing aids doesn’t serve any purpose. People usually don’t notice my hearing aids even though I wear bte aids with short hair until I tell them I have a hearing problem and point to my aids. They’re just not that observant. Also when I don’t explain my hearing loss they end up thinking I’m an idiot, which I might be anyway. There’s nothing to be ashamed about when it comes to hearing loss. It’s not you’re fault.

6 Likes

This! I struggle to see the benefit of making HAs invisible (unless it’s with the explicit purpose of trying to take advantage of exterior ear anatomy). I guess I understand vanity but really…Why does one care what others think? You’ll sleep better at night, trust me.

Actually when I saw this thread I thought it was going to be about fun colors. I mean, I have a bright orange car. My prior was bright yellow. I like fun colors.

3 Likes

I think you may have made them more visible now because the orginal clear tube would pick up the color of you skin and allow it to come through the tube thus blending into the area around the ear. jm2cw.

I hear what you are saying, i guess everyone is different, i don’t mind people noticing them as then they would know i struggle hearing but at same time my standard receivers are quite shiny and reflective which i kind of don’t like. I can always switch back to standard if i am in a situation where i feel people should notice them easier.

1 Like

@phobos512, For fun colors, check out the tube twists in my post above. Search online, you will find others as well.

1 Like

Oh interesting that’s not what I had imagined at all. I could have some fun with those depending on what I end up with here in the next few days. I could color coordinate with my car of the day lol.

1 Like